Code-3 OsciLaser Retrofit Manual de usuario

Busca en linea o descarga Manual de usuario para Encendiendo Code-3 OsciLaser Retrofit. Code 3 OsciLaser Retrofit User Manual Manual de usuario

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 4
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 0
Contents:
Installation & Mounting ............................................ 2-3
Product Returns ....................................................... 4
OSCILASER
RETROFIT KIT
INSTALLATION
& OPERATION
MANUAL
Read all instructions and warnings before installing and using.
INSTALLER: This manual must be delivered to the end user of this equipment.
IMPORTANT:
OLKIT
Vista de pagina 0
1 2 3 4

Indice de contenidos

Pagina 1 - RETROFIT KIT

Contents:Installation & Mounting ... 2-3Product Returns ...

Pagina 2

2Remove the reflector fromcarriage (save the 2 1/4 inchhex screws) and discard.Cut gray ground wireand discard.Desolder both wires atmotor, discard gr

Pagina 3

3Install new reflector. Attachground jumper and positivefeed wire.Detail of solder joint showingdirection of wires.Note gap between ground wireand p

Pagina 4 - PRODUCT RETURNS

LP6000 and XL5000 are trademarks and ArrowStik is a registered trademark of Code 3, Inc. a subsidiary of PublicSafety Equipment, Inc.3M is a registere

Comentarios a estos manuales

Sin comentarios