Code-3 PSE440 Remote Strobe Power Supply Manual de usuario

INSTALLATION& OPERATIONMANUALPSE440TMREMOTE STROBEPOWER SUPPLYContents:Introduction ... 2Sta

10MULTIPLE FLASH MODESBy selecting the proper switching, any number of flash modes can be used.Example: Quad Flash withFIGURE 7LOW CURRENT SWITCHING C

MaintenanceThe PSE440 Remote Strobe Power Supply has been designed to provide trouble free service. In case ofdifficulty , refer to the Troubleshootin

Code 3, Inc.10986 N. Warson RoadSt. Louis, Missouri 63114-2029—USAwww.code3pse.comProblems or Questions? Call our Technical Assistance HOTLINE - (314)

IntroductionThe PSE440 Series Remote Power Supply represents the latest in state-of-the-art strobe warning technology.The latest in MOSFET technology

The use of this or any warning device does not insure that all drivers can or will observe orreact to an emergency warning signal. Never take the rig

Installation and MountingMOUNTING THE MODEL PSE440 STROBE LIGHT POWER SUPPLYTo obtain maximum performance and durability the Model PSE440 strobe light

5RED WIRE - (ANODE) POSITION 1WHITE WIRE - (TRIGGER) POSITION 3STRIP INSULATION TO EXPOSEBARE WIRE AS SHOWNFIGURE 3AMP 3 PIN SOCKET HOUSINGPN 1-480303

FLASH CONTROL HARNESS ASSEMBLYThe Flash Control wire harness is to be connected to the 4 position socket connector on the PSE440 strobepower supply.

Flash Control Switching OptionsTo select any one of eight different FLASH MODES , simply connect the White, Orange, Yellow and Brownwires to a switch

The following diagrams show some of the wiring configurations possible for various flash modes. All fusesshown are to be customer supplied, and recomm

9SELECTIVE SWITCHING OF OUTLETS 1 AND 4 (only)OROUTLETS 2 AND 3 (only) IN HIGH POWERCYCLE FLASH MODESTANDARD DOUBLE FLASH MODE4 OUTLETS ON-OFF SWITCHI