Code-3 SuperVisor for Chevy Tahoe Manual de usuario

INSTALLATION& OPERATIONMANUALSUPERVISOR™Read all instructions and warnings before installing and using.This manual must be delivered to the end us

10FIGURE 15Lamps are extremely hot! Allow to cool completely before attempting to remove. Gloves andeye protection should be worn when handling halo

11LC-LED Light Head Flash Pattern SelectionThe LC-LED light heads are equipped with one steady burn and three flashing patterns. To select a differen

12PROBLEMLED module notoperating whenpowered.POSSIBLE CAUSEa. Bad power/groundconnection.b. Defective module.SOLUTIONa. Fix connection.b. Replace mo

13Parts ListReference Number Part Description Part Number1 +12V Cooling Fan T056122 *LED Module *Contact Code 3, Inc for P/N3 MR8 lamp, 13 degree spre

14Notes

15Notes

16Revision 1, 11/05 - Instruction Book Part No. T09624©2004 Code 3® Inc., a subsidiary of Public Safety Equipment, Inc. Printed in USAWARRANTYCode 3,

2IntroductionThe SuperVisor™ is an interior lighting system that fits in the visor area near the top of the windshield. It delivers an amazing warning

3Unpacking & Pre-installationCarefully remove the SuperVisor™ and place it on a flat surface, taking care not to scratch the lenses or damage the

4FIGURE 4FIGURE 3FIGURE 5Attach brackets to sun visor retaining clips In order to remove the sun visor retaining clip, unscrew the single torx scre

5FIGURE 6FIGURE 7Attaching the pivot arm bracketsAttach the outer brackets that are supplied noting the difference between passenger and driver side b

6FIGURE 9Mounting the SuperVisor™Before mounting the SuperVisor, apply gasket stripping to the front edge of the lower chassis in order to prevent scr

7Mounting the SuperVisor™ (continued)The two center brackets should line up with the holes in the SuperVisor's lower chassis. Using the supplied

8Wiring Diagram

9Wiring InstructionsLarger wires and tight connections will provide longer service life for components. For high current wires itis highly recommende