Code-3 RX 2700CC Manual de usuario descargar pdf (Pagina 7)

ArrowStik™ Pattern Selection

Introduction

The Central Controller is designed to offer user selectable trafc directing signals and trafc warning options.This allows the greatest exibility when

controlling the various RX 2700 congurations available. The end user can match the desired signal to a particular lightbar conguration whether it is

a 6, 7 or 8 lighthead conguration.

The lightbar will come from the factory with the default patterns selected as indicated in Table 2. The default conguration will be for a 7 head system

with all building patterns ( Building 7 HD ). If it is desired to change the pattern in any of the modes ( LEFT, CTR, RIGHT or FLASH ) or if you have

other then a 7 head system (6 or 8 head ) and you want to optimize the patterns for your particular conguration, then follow the programming

procedure outlined.

The Central Controller's Steady Burn feature allows up to two (2) of the light

bar's LED modules to be designated to operate in Steady Burn mode. The

Steady Burn LED modules are always connected to connectors P9 & P10.

The Steady Burn outputs are enabled by the 3-Level control inputs. The

Central Controller may be congured so that Steady Burn LEDs are on when

either L1, L2 or L3 are active (JP1 position); when L2 or L3 are active (JP2

position) or just when L3 is active (JP3 position). Simply move the jumper to

the appropriate location (JP1, JP2 or JP3). Refer to the detail in Figure 1.

FIGURE 1

Steady

Burn

Enable

Steady Burn L1, L2 & L3

Steady Burn L2 & L3

Steady Burn L3 only

Steady Burn Jumper Position

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Comentarios a estos manuales

Sin comentarios

Code-3 RX 2700CC Manual de usuario Pagina 7

Comentarios a estos manuales

Relacionado con productos y manuales para Encendiendo Code-3 RX 2700CC