Code-3 RX 2700CC Manual de usuario Pagina 1

1INSTALLATION & OPERATION MANUALFOR RX 2700™LIGHTBAR WITH CENTRAL CONTROLLERRX 2700™CENTRAL CONTROLLER LIGHT BARCONTENTS:Introduction...

10Lamps are extremely hot! Allow to cool completely before attempting to remove. Gloves and eye protection should be worn when handling halogen lamp

11RX 2700™ EXPLODED VIEW

12Parts List(Reference numbers identify items shown in Figure 7)Ref No. Description Part No. 1 Outboard Lens Cap Clear T03271 Red T03272 Bl

13TroubleshootingAll RX 2700™ Lightbars are thoroughly tested prior to shipment. However, should you encounter a problem during installation or during

14Notes:

15Notes:

WARRANTY Code 3®, Inc.’s emergency devices are tested and found to be operational at the time of manufacture. Provided they are installed and operat

IntroductionThe RX 2700™ Lightbar is approximately 2.7" high, yet delivers 360° of unobstructed warning signal. PriZm™ reector technology means

Unpacking & Pre-InstallationCarefully remove the lightbar and place it on a at surface, taking care not to scratch the lenses or damage the cable

Optional LED ArrowStik® featureThe CODE 3 Central Controller has an optional programmable ArrowStik® feature integrated into the light bar. The Arrow

LED DIRECTIONAL MODULESIn addition to the 360° warning modules the lightbar may be equipped with a number of single head front-rear warning LED module

Notes: *When the Pattern Select wire is connected to +power when all other inputs are off, test mode is enabled to exercise all outputsin sequence

ArrowStik™ Pattern SelectionIntroductionThe Central Controller is designed to offer user selectable trafc directing signals and trafc warning option

Selecting the ArrowStik™ Pattern As mentioned previously, the Central Controller will come from the factory with the ArrowStik patterns set in the def

MaintenanceLens CleaningUse plain water and a soft cloth, or Code 3® lens polish and a very soft paper towel or facial tissue. Plastic scratches eas