Code-3 MC SuperVisor Caprice Manual de usuario descargar pdf (Pagina 11)

Notes:

Troubleshooting

All SuperVisor-MCs are thoroughly tested prior to shipment. However, should you encounter a problem during installation or during

the life of the product, follow the guide below for information on repair and troubleshooting. Additional information may be obtained

from the factory technical help line at 314-996-2800. Follow the guide below for information on repair and troubleshooting.

TROUBLESHOOTING GUIDE

Note: LED modules must be replaced as a module. There are no user serviceable parts.

PROBLEM

LED module not

operating when

powered.

QUESTIONS POSSIBLE CAUSE

A. Bad power/ground

connection.

B. Defective module.

SOLUTION

A. Fix connection.

B. Replace module

N/A

This unit must be mounted within the interior passenger compartment of the vehicle only. It is not intended for

use in exterior applications. All devices should be mounted in accordance with the manufacturer’s instructions

and securely fastened to vehicle elements of sufcient strength to withstand the forces applied to the device.

Driver and/or passenger air bags (SRS) will affect the way equipment should be mounted. This device should

be mounted by permanent installation and within the zones specied by the vehicle manufacturer, if any. Any

device mounted in the deployment area of an air bag will damage or reduce the effectiveness of the air bag and

may damage or dislodge the device. Installer must be sure that this device, its mounting hardware and electri-

cal supply wiring does not interfere with the air bag or the SRS wiring or sensors. Mounting the unit inside

the vehicle by a method other than permanent installation is not recommended as unit may become dislodged

during swerving, sudden braking or collision. Failure to follow instructions can result in personal injury.

WARNING:

1 2 ... 6 7 8 9 10 11 12

Sin comentarios

Code-3 MC SuperVisor Caprice Manual de usuario Pagina 11