Code-3 Sprinter Manual de usuario descargar pdf (Pagina 5)

3. To install the positive and negative power wires, strip 1/4” of insulation from the end of the wires, and install the blade

connectors onto the ends of the appropriate wires. The “+12V” positions may be connected either directly to a +12V

source (such as a battery), or through a switch (such as an ignition switch). (See proper fusing requirements on page

6 prior to making any wire connections to battery or ignition switch)

Figure 1 - Wiring Diagram

1 2 3 4 5 6 7 8 9 10 ... 19 20

Sin comentarios

Code-3 Sprinter Manual de usuario Pagina 5