Code-3 XCEL Manual de usuario

1Contents:Introduction...2Congurable Features...

10XCEL Siren Wiring Diagram

11Siren SpecicationsSiren Section: Input Voltage 10 to 16 VDC and ground - 12V units (Note: Operation of 12V units above 15 VDC for an extende

12WARRANTY Code 3®, Inc.’s emergency devices are tested and found to be operational at the time of manufacture. Provided they are installed and oper

2!Sirens are an integral part of an effective audio/visual emergency warning system. However, sirens are only short range secondary warning devices.

3you will need to start again at step 4. Latching Auxiliary Buttons to 3 Level Switch - By moving the 3 level switch to any level, you can then press

4Standard Features- Cont:ALT TONE Rotary Knob - This position produces either Hi-Lo or Hyper-Yelp dependent on Dip Switch 12. Operation of thisfeature

5Standard Features- Cont:SirenLock - SirenLock is used to allow the XCEL Siren to only generate the tones when in Level 3. When SirenLock is enabled,

6Congurable Features for L6 ModelsDip Switch UP Dip Switch DOWNDip Switch 1 California Title 13 ON California Title 13 OFFDip Switch 2 Hands Free w/

7Unpacking & Pre-installationAfter unpacking your XCEL Siren, carefully inspect the unit and associated parts for any damage that may have been ca

8WARNING!Connection of a 58 watt speaker to the siren amplier will cause the speaker to burn out, and will void the speaker warranty!WARNING!Any ele

9Troubleshooting(Refer to wiring diagram on page 15.)PROBLEM PROBABLE CAUSE REMEDYNO SIREN OUTPUT A. PARK KILL ACTIVATEDB. SIRENLOCK ENGAGEDC. SHORTED