Code-3 Torus Lighthead Manual de usuario descargar pdf (Pagina 7)

WARNING!

6-LED Flash Pattern Selection

This unit will provide up to twenty one different ash modes. Each of

these modes can be selected by grounding and releasing the white wire.

As each ash mode is selected it is automatically programmed into the

unit such that when power is removed it will always return to the selected

mode the next time power is applied.

Maintenance:

The Exterior LED Modules are completely sealed units designed to be

trouble and maintenance free. Refer to the guide below for help with

troubleshooting. Should the unit be diagnosed as malfunctioning, remove

unit and replace with a new module.

TROUBLESHOOTING

Problem Probable Cause Remedy

Lighthead does not

activate

a. No Power to unit

b. Power input wire

reversed

c. Damaged or shorted

cabling

d. Defective Lighthead

e. Control wire permanently

grounded or shorted to

GND

a. Check wiring for

loose connection

b. Reverse Power wires

c. Check cables for

damage

d. Replace lighthead

module

e. Avoid permanent

grounding of control

wire

Lighthead is con-

stantly ON

a. Control wire permanently

grounded or shorted to GND

6-LED Flash Modes:

Alternating Simultaneous Steady with Flashing

Cycle Flash Quad Flash Fast Double Flash w/Steady

Single Flash Triple Flash Quad Flash w/Steady

Double Flash Double Flash

Triple Flash Single Flash

Quad Flash Pursuit Flash

Five Flash

Fast Single Flash

Fast Double Flash

Fast Triple Flash

Fast Quad Flash

Quad Pop Flash

Triple Pop Flash

Double Pop Flash

Wig-Wag Flash Alt.

Note: All modes ash at a rate of 70 fpm minimum. Fast modes ash at a rate of 100 fpm

minimum.

WARNING!

LED module housings may become hot with ex-

tended use. Allow modules to cool completely before

attempting to remove.

1 2 3 4 5 6 7 8

Comentarios a estos manuales

Sin comentarios

Code-3 Torus Lighthead Manual de usuario Pagina 7

Comentarios a estos manuales

Relacionado con productos y manuales para Encendiendo Code-3 Torus Lighthead