Code-3 Torus Lighthead Manual de usuario descargar pdf (Pagina 6)

3-LED Communications Set-up and Connections

With the Grey wires connected between the PARENT and one or more

heads set to CHILD mode, all CHILD heads will either ash Alternately

with the PARENT head or Simultaneously with the PARENT head

depending on the ash pattern selected. The following example shows

how to set-up a basic system with one PARENT head and three CHILD

heads. For this example two CHILD heads will ash Alternatively with the

PARENT head and one CHILD head will ash Simultaneously with the

PARENT head. All heads will be in the Cycleash pattern.

Step 1

One head will need to be selected to be in the PARENT mode. As

mentioned above, the heads are shipped in PARENT mode in the

factory default, Cycleash pattern. Select the desired head to be the

PARENT head. Power the head to verify that it is in Cycleash.

Step 2

Select one head to be the Simultaneous CHILD. Power the heads

and set this head to CHILD mode by holding the White wire to

Ground for 5 seconds or longer. If desired, you can test that it is

actually in the CHILD mode by temporarily disconnecting the GREY

wire. The head should stop ashing until reconnected. The head will

now be in CHILD mode in the Alternating Cycleash pattern.

Step 3

Set the ash pattern of the Simultaneous Child to Simultaneous

Cycleash. This can be done by momentarily touching the White wire

to Ground and releasing until the Simultaneous Cycleash pattern is

reached. To go from the factory default pattern of Alternating Cycle-

ash to the Simultaneous Cycleash pattern you will need to step

from pattern 1 ( Alternating Cycleash) to pattern 5 ( Simultaneous

Cycleash) as shown in the CHILD ash pattern table above. This

will require momentarily touching the White wire to Ground for 1 to 3

seconds, and releasing, four times. Remove and re-apply power to

the Parent and the Simultaneous Child. These two heads should now

be ashing together in Cycleash.

Step 4

Set the remaining two heads to CHILD mode by holding each of

their White wires to Ground for 5 seconds or longer. These heads

should now be in CHILD mode and in the factory default, Alternating

Cycleash, pattern. Remove and re-apply power to the PARENT and

CHILD heads. These heads should now be Alternately Cycleashing

with the PARENT head.

Note: Anytime you are not sure if a CHILD head is in an Alternating or Simultaneous pattern

you can always get back to the Alternating Cycleash pattern by stepping through patterns

until the SteadyBurn mode is reached. The next step will put the head into the Alternat-

ing Cycleash pattern. Remember that any CHILD head must be connected to a PARENT

head via the Grey wire, or to +12V, to enable ashing. PARENT heads will ash without any

communications connections.

1 2 3 4 5 6 7 8

Comentarios a estos manuales

Sin comentarios

Code-3 Torus Lighthead Manual de usuario Pagina 6

Comentarios a estos manuales

Relacionado con productos y manuales para Encendiendo Code-3 Torus Lighthead