Code-3 SuperVisor for Chevy Tahoe Manual de usuario descargar pdf (Pagina 6)

FIGURE 9

Mounting the SuperVisor™

Before mounting the SuperVisor, apply gasket stripping to the front edge of the lower chassis in order to prevent scratching the windshield (see

Figure 9). Once all four brackets and sun visors are attached, the SuperVisor is now ready to be installed. Fold both sun visors in the up position

(see Figure 10). Fold the rear view mirror down as far as it will go to get it out of the way for the SuperVisor. Position the SuperVisor by pointing the

center front portion of the lower chassis up above the rear view mirror and raise the back of the lower chassis into a level position. Position the

SuperVisor in the center of the windshield (as shown in Figure 11). Note:it may be necessary to gently pull back on the mounting brackets to

slip the SuperVisor's lower chassis behind the mounting brackets.

FIGURE 10 FIGURE 11

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

INSTALLATION 1
& OPERATION 1
SuperVisor™ 1
Introduction 2
Installation & Mounting 3
------Wire staking area 5
Mounting the SuperVisor™ 6
Wiring Diagram 8
Wiring Instructions 9
WARNING! 10
MR8 Alley Light Assembly 10
LED Fusing Considerations 10
Troubleshooting 12
Product Features 12
Parts List 13
WARRANTY 16
PRODUCT RETURNS 16

Comentarios a estos manuales

Sin comentarios

Code-3 SuperVisor for Chevy Tahoe Manual de usuario Pagina 6

Comentarios a estos manuales

Relacionado con productos y manuales para Encendiendo Code-3 SuperVisor for Chevy Tahoe