Code-3 WingMan for Chevy Impala Manual de usuario descargar pdf (Pagina 9)

This Product contains high intensity LED devices. To prevent eye damage,

DO NOT stare into light beam at close range.

LED Light Head Flash Pattern

Place the unit on a clean work surface and remove the outer cover. With the chassis facing up, locate each lighthead

module circuit board. To change the flash patterns of the LED Light Heads, touch both posts of the J1 header

simultaneously with an electrically conductive tool such as a screw driver blade (see figure 19 below).

Repeating this proceedure allows the operator to cycle through the numerous flash patterns offered until

the desired pattern is achieved.

Operating Specifications for directional module:

Operating Voltage: 10-16 VDC, Reverse Polarity Protection

Current Draw : Flashing Module

Red/Amber - .25A avg @ 12.8 Volts

Blue/White - .4A avg @ 12.8 Volts

Steady Burn Module

Red/Amber - .5A avg @ 12.8 Volts

Blue/White - .8A avg @ 12.8 Volts

Available Colors - Red , Blue, Amber, and White

LED MODULES

Directional module Flash Pattern - Table 2

PCB

CycleFlash (DEFAULT) Quad Pop Flash75

NFPA QuadFlash75 Triple Pop Flash75

Steadyburn SingleFlash375

ModelFlash SingleFlash250

ActiveFlash SingleFlash150

FiveFlash70 FiveFlash150

QuadFlash70 QuadFlash150

TripleFlash70 DoubleFlash150

DoubleFlash70 TripleFlash150

SingleFlash75

Flash Pattern Header for OPTIX/LEDX

Momentarily short and release

to change patterns

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Sin comentarios

Code-3 WingMan for Chevy Impala Manual de usuario Pagina 9