Code-3 LED Hide-A-Blast Manual de usuario descargar pdf (Pagina 4)

1. First, carefully plan the installation so that the HIDE-A-BLAST LED Lights will not interfere with the mount-

ing or operation of the vehicle's existing light xtures. Using a 1 inch hole saw, cut a hole in the vehicle's light

xture in a location that will allow the HIDE-A-BLAST LED light to be mounted in such a way that it will provide

maximum light inside the reector.

Wiring

1. Install the LED light heads in the desired locations.

2. Route the cables between the light heads and the control switch

panel. Make sure the cable is secure along the chosen routing inside

the vehicle to prevent damage by chang or binding. Be sure to keep

the cables away from engine hot spots.

3. Secure the cables and the HIDE-A-BLAST asher module using

plastic wire ties.

4. For synchronized operation of multiple HIDE-A-BLAST lights the

yellow wires from each unit's cable must be connected together.

Insulate this connection using an insulated butt splice to prevent

accidental contact with power or ground.

Connections:

Red +Power (10-30VDC)

Black Ground

Yellow Synchronization

Blue Pattern Selection

FIGURE A

Installation and Mounting

The HB Series LED Light components are water resistant but NOT waterproof and should

be located in an area protected from the weather and water.

WARNING!

1 2 3 4 5 6 7 8

Sin comentarios

Code-3 LED Hide-A-Blast Manual de usuario Pagina 4