
3
Re-installation of vehicle facia:
1. Pre-determine wiring connections for PAR 36 light heads prior to re-installation of vehicle facia.
2. Place vehicle facia into place and set top engine shroud over top edge of facia.
3. Place (2) plastic push-in fasteners through top engine shroud to hold it in place.
4. Hand insert and start one hex head fastener on each end of top engine shroud and through the top
leading edge of front facia. (These will hold facia in place for further installation)
5. Lift the wheel well trim cover and place facia into edges around each headlight and snap trailing edge
of facia into groove around front wheel well. The facia will snap into place on each side of the vehicle
at this point.
6.Re-install(1)phillipsheadscrewunderwheelwelltrimcoveratbothDS&PSoffaciarst.
7. Re-install phillips head screws through trim cover and facia and around each wheel well.
8. Re-install hex head screws along underside of facia behind air dam of lower facia.
WIRING CONNECTIONS:
1. Connect red wire from lighthead to +12V.
2. Connect black wire to ground.
3.BytouchingBluewiremomentarilytoground,selectionofdifferentashpatternscan
be made.
4. Yellow wire can be used for syncronization with other light heads in system.
g4g3
3. If you are installing the PAR 36 into a Ford PI Utility
Install light head and bracket into front facia using the (3)
sets of supplied U-Nuts and #10-24 Hex Head Screws.
If you are installing the PAR 36 into a vehicle that was
equiped with factory fog lights you can use the vehicles
original (3) phillips head screws from the fog lamp mount-
ing assembly. Do not tighten completely at this time.(see
g3.)
NOTE: The holes in the Par 36 Mounting Bracket are
oversize for ease of alignment of the Par 36 to the
facia opening and the wire slot has been rotated 90
degrees from the bracket shown in gure 3.
4. View Par 36 light head from front
offaciaandusetheexibilityof
the new mounting system oversize
holes to make alignment adjust-
ments to the opening. Tighten
screws on mounting bracket legs to
hold alignment.
NOTE: While vehicle facia is removed, installation of grill light brackets, speaker brackets
and wiring harnesses may be easily accomplished.
PAR 36 Light Head Installation Cont:
Comentarios a estos manuales