Code-3 Excalibur Manual de usuario descargar pdf (Pagina 13)

Electronics Module Removal

In the event that the power supply or a strobe lighthead assembly must be returned to the factory for service, mark each wire

with a tag to identify each function and note the proper location before disconnecting the wiring. Figure 9 can be used to mark

the locations of the individual connections as well.

Refer to Figure 9 for power supply removal. Remove the four (4) screws holding the power supply. Disconnect the wire leads,

and move the power supply to the side. Remove the 2 screws holding the capacitor assembly and lift the strobe power supply/

capacitor assembly from the lightbar as a unit. To reinstall the power supply reverse the above steps.

Caution: Verify that wires are not pinched or damaged when reinstalling power supply.

Strobe Lighthead

Assembly

Filter

(if supplied)

FIGURE 8

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Sin comentarios

Code-3 Excalibur Manual de usuario Pagina 13