Code-3 930 and 940 Flashers Manual de usuario descargar pdf (Pagina 4)

FIGURE 1: WIRING DIAGRAM FOR 930

LIGHT BAR FLASHER INSTALLATION

Terminal 10 - Output 2: 8 amps Maximum.

Terminal 11- To Battery Negative (-).

Provides the unit with ground (earth) to complete the circuit. For best results, connect directly to the

negative (-) terminal of the battery, or in light bar applications, connect to the light bar frame ground

(earth).ro

tect all wiring.

Terminal 12- Battery Positive (+12VDC).

Supplies Outputs +12VDC. The Unit should be fused with a user supplied 20 amp. fuse and wired with

#14 AWG wire minimum.

Flasher Installation

Flasher Installation (Model 930)

To install the Model 930 as an Alley Light flasher, refer to Figure 1 while following the steps below:

NOTE: Use #14 AWG wire (minimum) for all connections.

1) Mount the Flasher Unit in a convenient location inside the light bar or in the trunk (or console)

near the lighting control switch box.

2) Locate the +12V supply wire inside the light bar (or near the lighting control switch box) and

connect a 20 amp. fuse and holder in-line between the +12V source and Terminal 12 of the

Flasher Unit.

CAUTION: Leave the fuse out of the fuse holder until ready to test the circuit.

3) Install a user supplied switch in a convenient location near the driver.

4) Connect the user supplied switch between the positive source (+12VDC) and Terminal 2 of

the Flasher Unit.

5) Connect the Right Alley Light to Terminal 10 of the Flasher Unit.

6) Connect the Left Alley Light to Terminal 9 of the Flasher Unit.

7) (OPTIONAL) Connect the vehicle’s low beam switch to Terminal 1 of the Flasher Unit.

-

-

-

-

-

-

-

-

1 2 3 4 5 6 7 8

Sin comentarios

Code-3 930 and 940 Flashers Manual de usuario Pagina 4