Code-3 2011-2013 Explorer and Ford PI Utility Manual de usuario descargar pdf (Pagina 2)

Bolt - On Installation of Speaker Bracket to bumper system on vehicle:

(No Drilling Necessary)

g1

g2

g4

g3

NOTE: While vehicle facia is removed, installation of grill light brackets, Par

36 LED lighthead brackets and wiring harnesses may be easily accomplished.

1. removal of the front facia

exposes the bumper area for

speaker installation. Locate (2)

center holes in the mid section

2. install speaker onto bracket using the

hardware provided. Speaker should sit in-

sidebracketrecessasshowning.2.

3. install 4.5" stainless steel car-

riage bolts through retaining strap

bracket, (Included in kit), and

place through holes in center of

bumper.

4. place speaker bracket over bolt

ends with speaker facing forward

5.installatwasher,lockwasherandnuton

the back side of the speaker bracket.

6. slide bracket up in mounting slots and

tighten nuts using wrench.

NOTE:

Speaker should sit above lower lip of radiator hous-

ingandawayfromthefrontoftheradiatorns.

No contact with the radiator should be alowed.

(TOP VIEW)

(FRONT VIEW)

carriage bolts

retaining strap bracket

Below

bumper

install

shown.

DOMESTIC EXPLORER SHOWN:

1 2 3 4

Sin comentarios

Code-3 2011-2013 Explorer and Ford PI Utility Manual de usuario Pagina 2