Code 3 SuperVisor Manual de servicio

Read all instructions and warnings before installing and using. This manual must be delivered to the end user of this equipment.IMPORTANT:CONTEN

10NOTES:

11NOTES:

12Revision 2, 01/10 - Instruction Book Part No. T56364 ©2010 Public Safety Equipment, Inc. Printed in USACode 3®, Inc.10986 N. Warson RoadSt. Louis, M

2Unpacking & Pre-installationCarefully remove the SuperVisor and place it on a at surface, taking care not to scratch the lenses or damage the ca

3FIGURE 1 FIGURE 2 FIGURE 3Step 1 Removin

Step 6 Mounting the SuperVisor Outer Mounting BracketsWhile pushing up on the SuperVisor's Outer Panel under each of the inner mounting brackets,

The bracket fasteners make excellent hard mounting points for radar guns and video cameras, etc. Caution: Drilling into the housing of the light bar c

6Wiring Diagram - WITH TAKE DOWNSLarger wires and tight connections will provide longer service life for components. For high current wires it is hig

7Flash PatternsSTANDARD LIGHT HEAD FLASH PATTERNSPATTERN NO PATTERN DESCRIPTION1 FAST ALTERNATING QUAD FLASH 100ms/25ms2 PICKET FENCE SINGLE FLASH 200

8Parts ListReference Number Part Description Part Number 1 Outer Mtg. Brkt. Pass Side T14763

9NOTES: